Tools

It's been a while, since I had an opportunity to work on a lathe, so before mounting the clutch, I turned a centering tool. It was great being back, and I must admit, I do miss it. The tool turned out fine, see pictures below.














I'll try to post the drawing at the homepage, and if unsuccesfull, you are welcome to contact me by email, and I will see, if I can send it to you.
Alot of people just cut the shaft off of an old gearbox, but as I had a chance to brush up on old skills, and make it in stainless steel, I did- this way I also have a custom tool, which is always kuul.

Next steps for Hippo is mounting of the new clutch bearing, gearbox mounted to engine again and into the enginebay.

Keep 'em kruzin!
Dannerr